MIL-PRF-49471/6A(CR)
Capacity tests: When the battery is tested in accordance with the methods of examination and
tests of this specification, the minimum capacity test requirements shall be as specified below:
Capacity Test* Minimum Capacity Requirements in Hours to
20.00 volts in Series
10.00 Volts in Parallel
I & IP
3.0
L & LP
1.5
H & HP
5.5
HT & H
5.3
LT & LTP
1.3
IT & ITP
2.8
LR1
45.0
*NOTE: Sample batteries that are to be assigned to a capacity test (except the LR1 test) shall be
equally divided between the designated capacity test and the capacity test ending in P (e.g. I and
IP). The odd battery, if present, is assigned to series discharge capacity test. For the capacity
tests that do not have the P's, the battery's legs shall be discharged in series. For the capacity
tests that have the P's, the battery's legs shall be discharged in parallel.
Initial voltage delay: During the I, H, HT, and IT discharge tests of the two (2) 12 volt sections
connected in series under the designated loads, initial voltage below the 20.00 volt minimum
voltage cannot exceed a 5.0 second duration. During L and LT discharge tests initial voltage
below 20.00 volts cannot exceed a 60 second duration. During the IP, HP, HTP, and ITP
discharge tests of the two (2) 12 volt sections connected in parallel under the designated loads,
initial voltage below the 10.00 volt minimum voltage cannot exceed a 5.0 second duration.
During LP and LTP discharge tests initial voltage below 10.00 volts cannot exceed a 60 second
duration.
Connector: The connector configuration and operating temperature range requirements shall be
certified in the First Article Test Report. The connector shall be in accordance with SC-C-
179492 with the following exceptions: (1) Sheet two of SC-C-179492 does not apply. (2)
Mounting screws are optional. (3) Operating temperature range for the connector shall be from a
low of-55oC to a high of 125oC. (4) The connector test described in paragraph 4.7.15 shall be
performed 10 times with SM-D-687888. (5) Each of the metallic sockets in the connector (top
view) shall conform to Figure 2. Each socket shall be cylindrical in shape and may have a single
gap with a maximum opening of 30 degrees. The socket shall accept a number 16 pin.
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business