MIL-PRF-49471/6A(CR)
NOTES:
1. All dimensions are in inches.
2. Tolerances, unless otherwise specified, are +.030 inch.
3. The battery terminal shall consist of a miniature circular battery connector, Dwg SC-C-
179492, except as noted herein.
4. Connector socket body configuration shall accept two (2) each 0.156 inch minimum diameter
guideposts as shown. Depth of cavity shall be 0.657 inch minimum.
5. The socket (connector) shall be supported and mounted so that the top surface of the socket
shall not protrude above the adjacent outside surface of the jacket and shall not be more than
0.0625 inch below adjacent outside of the jacket when used initially, during and after subsequent
insertions of the mating plug. This shall be certified in the First Article Test Report.
REQUIREMENTS:
Dimensions and configuration: See Figure 1.
Maximum voltage:
33.0 volts in 24 volt mode
16.5 volts in 12 volt mode
Cut-off voltage for capacity: 20.00 volts in 24 volt mode
10.00 volts in 12 volt mode
Terminals: Six (6) hole socket type with no obstruction of any holes (see Fig. 1).
Weight (maximum): 1.65 pounds (748 grams).
Battery short circuit test: Applicable.
Charge protection: Applicable.
High temperature protection: Applicable.
Complete discharge device: Applicable.
State of Charge Indicator: Not applicable.
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business