MIL-PRF-49471/1A(CR)
NOTES:
1. All dimensions are in inches.
2. Tolerances, unless otherwise specified, are -.063, +.000.
3. The battery terminal shall consist of a miniature circular battery connector, Dwg SC-C-
179492, except as noted herein.
4. Connector socket body configuration shall accept two (2) each 0.156 inch minimum diameter
guideposts as shown. Depth of cavity shall be 0.657 inch minimum.
5. The socket shall be supported and mounted so that the top surface of the socket shall not
protrude above the adjacent outside surface of the jacket and shall not be more than 1/16 inch
below adjacent outside surface of the jacket when used initially, during, and after subsequent
insertions of the mating plug during contractual testing.
REQUIREMENTS:
Dimensions and configuration: See Figure 1.
Maximum voltage: 9.90 volts.
Cut-off voltage for capacity: 6.00 volts
Terminals: Six (6) hole socket type with no obstructions of any holes (see notes 3 and 5).
Weight (maximum): 1.5 pounds (680 grams).
Charge protection: Applicable.
Battery Short Circuit Test: Applicable.
State of Charge Indicator: Not applicable
High temperature protection: Applicable.
Complete discharge device: Applicable.
Capacity tests: When the battery is tested in accordance with the methods of examination and
tests of this specification, the minimum capacity test requirements shall be as specified below:
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business