MIL-PRF-49471/5A(CR)
NOTES:
1. All dimensions are in inches. The tolerance shall be ±0.031 inch unless otherwise specified.
2. The dual connectors shall be wired in a parallel 6 volt circuit.
3. Type IV socket:
a. Pin circle center shall be on the battery center line.
b. Minimum depth of the socket well shall be 5/8 inch.
c. Shall float 1/32 inch minimum in all directions from the pin circle center.
d. Positive terminal shall be the 5/32 inch dia. Socket (see Figure 1, View A).
4. Flat contacts:
a. The center negative contact shall be on both battery center lines.
b. Shall be supported and mounted so that the top surface shall not protrude above the
outside surface of the battery jacket.
c. Shall not be more than 1/8 inch below the outside surface of the battery jacket initially,
during, and after contact is made with mating contact springs.
d. Shall not have a lateral displacement of more than 1/32 inch during mating with
contact springs.
5. Terminal polarity and voltage shall be as shown in Figure 1.
6. Insertion Force: 12 pounds MAX. Withdrawal Force: 3 pounds MIN.
7. Socket requirements to be certified in the First Article Test Report.
REQUIREMENTS:
Dimensions and configuration: See Figure 1.
Maximum voltage: 6.10 volts.
Cut-off voltage for capacity: 4.00 volts.
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business