MIL-PRF-49471/2A(CR)
NOTES:
1. All dimensions are in inches.
2. Tolerances, unless otherwise specified, are +0.005 inch for decimals.
3. Tolerances for length, width, and height of battery are +1/16 inch for fractions.
4. The minimum depth of socket well shall be 1/2 inch.
5. The size of the insulating plate is optional.
6. Socket insert contact not required.
7. Pin-circle center.
8. "D" hole for plug positioning.
9. Five holes to fit 1/8 inch minimum pins, 7/16 inch minimum in length.
10. Socket must float 3/32 + 1/32 -1/16 inch in all directions from the specified pin circle center
location in the plane of the socket from reference dimension.
11. The socket shall be supported and mounted so that the top surface of the socket shall not
protrude above the adjacent outside surface of the jacket and shall not be more than 1/16 inch
below adjacent outside surface of the jacket when used initially, during and after subsequent
insertions of the mating plug during contractual testing.
12. Hole numbers are for reference only and need not be marked on the terminals.
REQUIREMENTS:
Dimensions and configuration: See Figure 1.
A1 Unit
A2 Unit
Voltage Requirements:
Maximum voltage:
3.30
16.50
Cut-off voltage:
2.00
10.00
Terminals: Five (5) hole socket type with no obstruction of any holes.
Weight (maximum): 2.25 pounds (1020 grams).
Charge protection device: Applicable.
Battery Short Circuit Test: Applicable.
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business